PicoScope T&M 7.2.30.10460

What's new in 7.2.30.10460

New features:

• Serial decoding Action event: Actions can now be triggered when a serial decoder finds specified data or a decode error. Use it to stop the capture, save the file or play a sound the moment the event is decoded, so intermittent bus faults can be caught during unattended monitoring.
• Custom probe ranges: when creating or editing a custom probe, you can now set its ranges manually. This allows unipolar ranges, or ranges match the output of a specific sensor.
• ZACwire (OWI) serial decoder: new decoder for the ZACwire One-Wire Interface (OWI), the single-wire protocol used to calibrate, configure and read sensor signal conditioner ICs originally developed by ZMD (now Renesas), and the pressure, temperature and bridge sensors built on them.
• JTAG serial decoder: new decoder for JTAG (IEEE 1149.1), the test and debug interface used for boundary scan, device programming and on-chip debugging.
• Channel Deskew can now be set up to 20ms.
• Adding Notes will now automatically bring the caret into the Notes viewport.
• User Offset Correction no longer requires external 50R termination on most 6000E scopes.

Bug fixes:

• Fixed: the CAN FD decoder could stop decoding during continuous capture after it encountered an error in the bus data.
• Fixed: the RPM ruler in Spectrum view showed an incorrect reading.
• Pinch zoom on touchscreens now locks to the intended axis more reliably.
• Time values of 1 minute or more now use a consistent days, hours, minutes and seconds format (for example, 1d 2h 30m 15s).
• Fixed: the UI could stop responding while the Math Channel options panel was open.
• General stability and minor UX improvements.